• RAMPS1.4

Reprap Arduino Mega Pololu Shield or RAMPS for short. 

Full details of this open source hardware design can be found on the Reprap Wiki here:http://reprap.org/wiki/RAMPS_1.4

The 1.4 version is the latest version and incorporates the use of surface mount electronic components.

The shield is fully assembled. You will need to add an Arduino Mega 2560 or equivalent clone, the stepper driver modules and a power supply and you will have all the electronics necessary to drive a 3D printer.

The shield provides for:

Sockets for up to 5 Pololu style stepper drive modules. X, Y, and Z axes and 2 extruders.

3 channels of temperature sensing using 100k thermistors (not included) for heated bed, and 2 extruders

3 channels of MOSFET switched output for controlling extruder heating, hot bed heating and cooling fan speed.

 

RAMPS1.4

  • Brand: Geeetech
  • Product Code: RAMPS1.4
  • Availability: Out Of Stock
  • $24.95

  • Ex Tax: $21.70

Related Products

RAMPS RRD Fan Extender

RAMPS RRD Fan Extender

This board provides an additional 2 outputs for fans, LED lighting etc. on a RAMPS controller If yo..

$12.95 Ex Tax: $11.26

SD Card Breakout for RAMPS

SD Card Breakout for RAMPS

This is an Add-on for RAMPS boards that allows you to connect a micro SD card to your controller. Y..

$14.95 Ex Tax: $13.00