Jumper 3 pin Dupont 70cm

Jumper 3 pin Dupont 70cm
Product Code: JumperDupont3x70cm
Availability: Out Of Stock
Price: NZ$1.20
Ex Tax: NZ$1.04

10 or more NZ$1.10
Qty:   Out Of Stock   - OR -   Add to Wish List
Add to Compare

Looking for a way to connect your Limit switches to your controller board?  Here's a solution for you.

These jumpers consist of 3x 70cm long wires with a 3 pole female DuPont type connector on each end.

Simply cut them to the desired length and solder them onto the opto switch or microswitch.

3 pin cables are required for elctronic limit switches where +5V and Ground are required as well as the wire carrying the signal back to the controller.

For a simple mechanical microswitch only 2 wires are needed.



Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

© MAKERshop 2021